The MA Defense Pinnable Gas Block, our design allows it to
be quickly pinned to your barrel. The pre-drilled hole means there is no wasted
time by drilling through the gas block. The bottom hole is positioned low
enough so only remove the necessary amount of material from your barrel. Since you
have to remove less material, pinning the barrel is easier to accomplish with a
standard hand drill or drill press. These gas blocks were designed with some pretty tight tolerances, you may have to use a gunsmith hammer to tap it on or heat the gas block to get it you fit your barrel. We always recommend that a competent armorer/gunsmith
do the installation.
- Material 4140 Ordnance steel
- Set screw distance (center to center) 0.425 inches
- Barrel profile: .750 gas block journal
- Heat treated
- Nitride finish
- 1/8 HD steel coil pin & HD steel gas tube roll included
- Knurled head Set Screws included
- Instruction/Data packet
ITAR: International Traffic in Arms Regulations Controlled